Feed Pellet Mill

Feed pellet mill belongs to feed granulating equipment, it is a feed processing machinery, materials such as corn, bean dregs, straw, grass and rice hull can be directly used to press feed. Take straw mixed particles feed processing technology for example, in the past straw stalk feed is generally processed into powder and mix in feed, existed disadvantages are not convenient for feeding, poor palatability, picky livestock, low utilization rate and so on. With the introduction and popularization of this feed pellet mill, now we can easily make powder feed into granule feedstuff anytime anywhere.

This small grain feed processing machinery can use light as a driving force, the powder feed get gelatinized through high temperature, and feed granules expelled from model hole under the pressure of pressure roller, it's easy to adjust the size of the granules, its simple structure is suitable for rural farmers and small family professional feed factory. Straw feed processing as grains after feed has many advantages.

If we bought a feed pellet mill machine, place it smoothly when install the machine, connect up good power supply according to the turning direction of the machine, check each place to make sure there is no loose screw, adjust the tightness of rewinding belt moderately, adjust the balance between die plates and two roller, the gap between roller and die plates should be 0.1-0.3 mm. Put up good abrasive materials in certain proportion to grinding machine, generally we mix grass powder 5 kilograms, used oil 0.8 kilograms, water 0.7 kilograms, sand 2 kilograms together and stir evenly, then grind the machine for 30 minutes or so with the mixture.

Determine the correct installation of the feed pellet mill machine, according to the certain proportion requirements stir bulk material evenly, generally speaking it is appropriate that every hundred kilograms of dry feed with 3.5 kilograms water. At first add a little mixture to the machine, wait until it extruded the granular feed, check the quality of the granule feed, fill material in feeding mouth to normal production if the quality is satisfied. It is strictly prohibited to mix the feeding in the hopper with hand. After the operation is completed, we should remove the remaining material in the machine in case of mildew.

The length of granule depends the length of the discharge mouth, the length of granule can be adjusted by adjust the position of cutting knife on the upper end of discharge mouth, diameter of granule feed depends on the bore diameter, we need to exchange the die to adjust the diameter of granule feed appropriately. Every time after use the new machine need a swill, after 15-20 times can stop swill. When produce 1000 kilograms granule feedstuff, need to turn over die plate to continue using, this can lengthen its service life. The production need no preheat, raw material of feed is varied, and surface of the granule feed is smooth, hardness is modest, internal maturation degree is high, improve nutrition, increase appetite of livestock.